Using The Clip Battery Cover; Using The Safety Strap - Tanita AM-120E Manuel D'instructions

Using the Clip Battery Cover

Using the Safety Strap

Open
Close
1) Remove the battery cover.
Loosen the 2 screws, and remove the
battery cover. See P. 9.
2) Attach the battery cover with clip.
Insert in the direction shown by the
arrow, and securely tighten the 2
screws.
Note: Make sure that the inner ring is
installed securely in the groove.
Attaching the strap
Note: Do not pull the strap sharply. Doing so may
cause the strap to stretch or break.
Opening/Closing the clip
Note: Do not pull the strap sharply when the clip is
closed. Doing so may damage the fabric that the
clip is attached to.
19
Eng