Inserting/Replacing The Battery - Tanita AM-161 Manuel D'instruction

Inserting/Replacing the Battery

Inserting the Battery
Use a coin to loosen the
battery cover and then
remove the cover.
Replacing the Battery
The following indicators are displayed when the battery is low. When these indicators appear, replace
the battery with a new CR2032 battery as soon as possible.
flashes
is displayed.
* The battery provided is a test battery, and may therefore have a short service life.
The battery can be removed easily by prizing off the part shown in the figure with a fine-tipped object.
Reconnect the Activity Monitor to your smartphone after replacing the battery (see p.9).
・ Do not replace the battery between 11:55 pm and 12:05 am (midnight). Doing so may interfere with the data.
・ Measured values are recorded to the memory once every hour on the hour (e.g. 3:00pm). If, for example,
the battery is replaced at 3:35pm, the measured values from 3:00 to 3:35pm will be lost.
・ To keep as much of the data as possible, we recommend changing the battery at around one minute past
the hour (e.g. 3:01pm).
Keep batteries out of reach of infants and small children.
→
Otherwise, they may swallow a battery. In the event of swallowing, consult a doctor
immediately.
PROHIBITED
TOP
Insert the battery (CR2032) in the
direction of the arrow, with the +
side facing up.
* Return the inner ring to its original
position if it comes loose.
： Battery power is running low. The device cannot communicate.
： Battery power has run out. The device cannot take measurements or communicate.
*The battery is designed to be difficult to remove by hand to prevent infants and small children
from swallowing the battery.
*After removing the battery, wait for the display to go blank before inserting the new battery.
WARNING
Inner ring
NOTE
7
Mark
Align the battery cover with
the mark and close it using
the coin.