Tanita AM-161 Manuel D'instruction page 16

Troubleshooting
If this occurs
flashes
is displayed
Nothing is displayed even
when batteries are inserted
Too few/too many measured
values
"Running" has been counted even
though I have not been running.
is displayed during use.
Cannot connect the device and
smartphone. The device is reset and
is displayed.
Cannot connect the device and
smartphone.
or is displayed.
is displayed repeatedly.
is displayed.
is displayed.
, or is displayed.
・ If there are any other unusual items shown on the display, contact Tanita via www.tanita.eu
TOP
□Battery power is running low. The device cannot communicate.
Replace the batteries (CR2032) as soon as possible.
□Battery power is running low. The device cannot take measurements or communicate.
Replace the batteries (CR2032) as soon as possible.
□Are the batteries inserted in the correct orientation?
Check the + and - marks on the batteries.
□Battery power is running low.
Replace the batteries (CR2032) as soon as possible.
□Check "How to Use the Activity Monitor Correctly : Wearing" and
"How to Use the Activity Monitor Correctly : To Ensure Accurate Measurements".
□Are the setting details correct?
Check the personal settings in the dedicated app.
□The timing at which batteries are replaced may affect data storage.
□ "Running" may be counted if you walk down stairs at a quick pace.
□There may be a connection problem.
Remove and reinsert the batteries.
□If this occurs frequently, the battery power may be running low.
Replace the batteries (CR2032).
□The device may be reset during communication if the batteries are running low.
Replace the batteries (CR2032).
□ Is
flashing?
The communication function turns off when the batteries are running low.
Replace the batteries (CR2032).
□Are the device and smartphone out of communication range?
The communication distance with the device is approximately 5 meters
in an unobstructed location.
□Is "Bluetooth" set to "On" in the smartphone "Settings"?
□Delete the device pairing from the smartphone in "Settings" > "Bluetooth",
and then pair with the device again.
□Are the setting details correct?
Check the personal settings in the dedicated app.
□A system error has occurred. Remove and reinsert the batteries.
16
Check this