Tanita AM-120E Manuel D'instructions page 9

Note:
The batteries included are installed in the factory before shipment, and may therefore run
down before 9 months.
Note: When replacing the batteries, always remove both batteries at the same time, and
replace both with brand new batteries.
1) Use the included screwdriver or
a commercially available small
screwdriver to loosen the 2
screws in the battery cover on the
back of the device.
2) Remove the battery cover.
When removing the battery cover, the
inner ring may also come out of the
groove in the device body. Make sure
you do not lose this ring.
3) Insert a strong, thin stick into the
hole and remove the batteries
Note: Do not use metallic tweezers or
a screwdriver etc.
9
Continued on next page
Eng