VONROC AG501DC Traduction De La Notice Originale page 9

TECHNICAL SPECIFICATIONS
Model No.
Voltage
No load speed
Grinding disc
Diameter:
Bore:
Spindle thread
Weight
Sound pressure level L
PA
Acoustic power level L
WA
Vibration a
h,AG
Wear hearing protection.
Only use the following batteries of the VONROC PO-
WER 20V battery platform. Using any other batteries
could cause serious injury or damage the tool.
CD801AA 20V, 2Ah Lithium-Ion
CD803AA 20V, 4Ah Lithium-Ion
The following charger of the can be used to charge
these batteries.
CD802AA Quick charger
The batteries of the VONROC POWER 20V battery
platform are interchangeable with all the VONROC
POWER 20V battery platform tools.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
WWW.VONROC.COM
AG501DC
20V
8.000/min
115 mm
22.2 mm
M14
1.55 kg
75.7 dB(A), K=3dB(A)
86.7 dB(A), K=3dB(A)
5.642 m/s , K=1.5 m/s
2 2
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2 - 4.
1. Spindle lock button
2. Release lever for protection guard
3. Protection guard
4. Machine
5. On / off switch
6. Side handle connection point
7. Spindle
8. Side handle
9. Mounting flange
10. Wheel disc (not included)
11. Clamping nut
12. Spanner
13. Battery (not included)
14. Battery unlock button
3. ASSEMBLY
Before any work on the power tool, remove
the battery.
The battery must be charged before first use.
Inserting the battery into the machine (Fig. C)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (13) into the base of the
machine as shown in Fig. C.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. C)
1. Push the battery unlock button (14)
2. Pull the battery out of the machine like shown
in Fig. C.
Assembling the protection guard (Fig. E and F)
1. Place the machine on a table with the spindle
(7) facing upwards.
2. Place the protection guard (3) over the machine
head as shown in Figure E making sure the
ridges on the protection guard fall into the
notches of the machine head.
3. Turn the protection guard counter clockwise as
shown in Figure F and clench the release lever
for protection guard (2).
EN
9