Troubleshooting Tips
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY
INTERFERENCE STATEMENT (U .S .A . ONLY)
This equipment generates and uses ISM frequency
energy and if not installed and used properly, that is in
strict accordance with the manufacturer's instructions,
may cause interference to radio and television
reception. It has been type tested and found to comply
with limits for ISM Equipment pursuant to part 18 of
FCC Rules, which are designed to part 18 of FCC
Rules, which are designed to provide residential
installation.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause interference to radio or television reception, which
can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference
by one or more of the following:
■ R eorient the receiving antenna of the radio or
television.
■ R elocate the Microwave Oven with respect to the
receiver.
■ M ove the microwave oven away from the receiver.
■ P lug the microwave oven into a different outlet so that
the microwave oven and the receiver are on different
branch codes.
The manufacturer is not responsible for any radio of TV
interference caused by unauthorized modification to this
microwave oven. It is the responsibility of the user to
correct such interference.
Supplier's Declaration of Conformity
47 CFR § 2 .1077 Compliance Information
Unique Identifier: Microwave, CSB923
Modular Component: Wireless LAN Module
Modular Component FCC ID: COF-WMBNBM26A
Responsible Party:
FCC Compliance Statement: This device complies with
part 18 of the FCC Rules.
FCC Compliance Statement: This device complies with
part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may
cause undesired operation.
24
GE Appliances
Appliance Park,
Louisville, KY 40225
cafeappliances.com
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
■ R eorient or relocate the receiving antenna.
■ I ncrease the separation between the equipment and
receiver.
■ C onnect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
■ C onsult the dealer or an experienced radio/TV
technician for help.
To satisfy FCC RF exposure requirements, a separation
distance of 20 cm or more should be maintained
between the antenna of this device and persons during
device operation.
To ensure compliance, operations at closer than this
distance is not recommended.
Any changes or modifications to this
WARNING
unit not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
49-2000418 Rev.0