Sony VPL-VW10HT Mode D'emploi page 28

The INSTALL SETTING Menu
DIGIT KEYSTONE
Corrects the trapezoid caused by the projection angle.
If the base edge is longer, set a negative value; if the
upper edge is longer, set a positive value to square the
image.
Note
If "ZOOM", "FULL" or "NORMAL" have been
selected in the ASPECT of the INPUT SETTING, you
can change the trapezoid.
INSTALLATION
Sets to reverse the picture horizontally or vertically.
FLOOR-FRONT: The picture is not reversed.
CEILING-FRONT: The picture is reversed
horizontally and vertically.
FLOOR-REAR: The picture is reversed
horizontally.
CEILING-REAR: The picture is reversed
vertically.
Note
In case of using a mirror, be careful of installation
since the picture may be reversed.
CINEMA BLACK
Switches the lamp wattage during projection.
OFF: Normal wattage.
ON: Enhances the black by reducing the lamp
wattage.
If the CINEMA BLACK is set to ON, the next time
the power is turned on, the lamp will use the OFF
setting for the first minute, and then go to ON.
It will take 2 - 3 seconds to change the wattage.
LAMP TIMER
Indicates how long the lamp has been turned on.
Note
This only displays the time. You cannot alter the
display.
28
(GB)