EINHELL BT-SP 1300 Mode D'emploi D'origine page 16

Anleitung_BT_SP_1300_SPK1:_
GB
The feed table (13), planing table (14), thicknessing
table, feed/discharge rollers and anti-kick claws (24)
must be kept free of resin at all times. Soiled
feed/discharge rollers or anti-kick claws (24) must be
cleaned without delay.
To prevent the motor overheating, the dust that
accumulates in the ventilation openings must be
removed at regular intervals.
Improve the smooth running of the tables by applying
lubricant at regular intervals.
14.2 Cutting tool
Resin must be cleaned off the knife (21), latch (22)
and knife block (23) at regular intervals. Clean these
components with an appropriate resin remover.
15. Troubleshooting (Figure 1)
1. The machine cannot be switched on:
No mains power. Check the power supply.
Carbon brushes worn. Have the carbon brushes
replaced by an electrician.
2. The machine cuts out when idling:
Power failure (check fuses). Have the fuse
replaced by an electrician.
3. The machine cuts out when planing:
Blunt knife or feed speed too high. Replace the
knife or reduce the feed speed.
4. Loss of speed when planing:
Cutting depth too deep. Reduce cutting depth.
Feed speed too high. Reduce feed speed.
Blunt knife. Replace knife.
5. Poor surface quality on the planed
workpiece:
Blunt knife. Replace knife.
Uneven feed. Feed the workpiece at constant
pressure and reduced feed speed.
Dust extraction system (not supplied) not
connected. Connect dust extraction system.
6. Chip discharge for surfacing or thicknessing
blocked:
Dust extraction system (not supplied) not
connected. Connect dust extraction system.
Wood too wet.
7. Uneven feed speed for thicknessing:
Rubber belt too loose. Check rubber belt and
replace if necessary.
16
02.09.2010 11:29 Uhr Seite 16
Thicknessing table (20) soiled. Clean the
thicknessing table (20) and treat with a lubricant
if necessary.
16. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
16.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
16.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
16.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
17. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.