Maintenance And Care - T.I.P. SSI 600 LED Mode D'emploi D'origine

For this purpose, the solar-powered device has to be charged for at least 8 hours in direct sunlight before
installation. Neither the pump nor the lighting unit may be switched on during the initial charging process. Make
sure that no shade falls on the solar panel, otherwise the charging capacity will be reduced. If the unit has not
been in operation for a long time, the above procedure has to be repeated.
Remote control:
When you now press a button on the remote control, the green LED light on the remote control comes on. The
different operating modes can be reached by pressing the buttons on the remote control several times.
Press the button "A" to select the duration of the operation:
1x press 1 hour, 2x press 2 hours, 3x press 3 hours and 4x press 4 hours of operation (depending on the battery
charge level).
By pressing the "B" button, you can switch on the white LED lights at dusk or in the dark.
Press button "C" to set the height of the water fountain and the interval spray. There are three different levels in
total.
To switch the pump on and off, press the button "D" on the remote control. By pressing once, a continuous
operation mode can be selected. If the power is less than 3.5 V, the pump will automatically switch off / not switch
on.

8. Maintenance and care

Attention:
For all maintenance and care work, the plug connection between pump and solar unit or the control housing must
be disconnected! For this purpose, the device must be switched off and removed from the water.
Collector surface:
The solar collector should be cleaned at regular intervals with a soft cloth. Regular cleaning is recommended to
ensure optimal absorption and conversion of sunlight into energy.
Pump:
If after a certain time the pump loses flow or does not work
at all, check if there is sediment, sludge or other dirt in the
filter of the pump. Remove the pump and impeller cover.
Clean both with lukewarm water and a soft brush.
Battery:
The SSI is equipped with a long-lasting and powerful
lithium-ion battery 3.7 V - 2000 mAh, which cannot be
replaced.
Please pay attention to the instructions under point 7 for regular charging of the device to maintain the battery
function.
8.1. Maintenance intervals
The time intervals for the necessary maintenance work (complete cleaning) depend strongly on the pond water
contamination. Choose the intervals for cleaning accordingly.
If you find defects or wear and tear during maintenance, replace the corresponding parts.
(See spare parts ordering)
8.2. Winter maintenance
Protect your pump from frost! Remove the pump from your garden pond if there is a risk of frost.
Before taking the device out of operation for a longer period of time (e.g. in winter), it is recommended to charge
the battery completely. Here the device should be charged for several hours in direct sunlight without the pump
and lighting being switched on. You should repeat this charging process at least every 3 months when the device
is taken out of operation.
Clean the pump completely according to the instructions.
Please make sure that the device is switched off during winter and that the connection cable of the pump is
disconnected from the control box to avoid discharging the battery. Please store the device during the winter
months in heated rooms to reduce the self-discharge of the battery.
8
3