Star Progetti HELIOSA HI DESIGN 993 Mode D'emploi page 6

WARNING
READ THE INSTRUCTIONS CONTAINED IN THIS BOOKLET CAREFULLY BEFORE USING THE APPLIANCE.
STAR PROGETTI CANNOT ASSUME ANY RESPONSIBILITY FOR DAMAGE TO PROPERTY OR PERSONAL
INJURY RESULTING FROM FAILURE TO ABIDE BY THE INSTRUCTIONS GIVEN IN THIS BOOKLET.
FOLLOWING THESE INSTRUCTIONS WILL ENSURE A LONG SERVICE LIFE AND OVERALL ELECTRICAL
AND MECHANICAL RELIABILITY. KEEP THIS INSTRUCTION BOOKLET IN A SAFE PLACE.
Do not use this appliance for functions other than those described in this booklet.
1.Connect HELIOSA 993 to a single-phase 220-240V supply (varies from country to country).
2. HELIOSA 993 must be earthed.
3. Check that the power supply is suitable for the load to be installed.
4.Only touch the end caps. Should you accidently touch the surface of the bulb, clean it immediately with a soft cloth
moistened with alcohol.
5. Do not cover or obstruct the appliance whilst it is on.
6.Replacement of the supply cable must only be carried out by the manufacturer or the help service or a specialised
technician.
7. This appliance is manufactured to a high standard of craftsmanship: to ensure a long service life and overall
electrical and mechanical reliability it must be used in a proper manner and subjected to regular maintenance.
8.After unpacking the product, check that everything is there; if in doubt contact the manufacturer or an authorized
Technical Assistance Centre.
9. Do not leave any packaging in the reach of children or the handicapped.
10. Certain fundamental rules must be observed when using any electrical appliance:
-Never touch appliances with wet or damp hands
- Never touch appliances while barefoot
-If using this appliance where there are children, supervision by an adult is necessary; this appliance must not be used,
without assistance, by children or persons whose physical, sensory or mental capacities prevent them from applying
the necessary safety precautions.
11.Do not use the appliance where there are inflammable substances or vapours such as alcohol, insecticides, petrol,
etc.
12.If you decide to permanently remove the appliance, switch it off and disconnect it from the mains, and then keep it
well out of the reach of children and the handicapped. It is also recommended to make it unusable by cutting its supply
cable off.
13.Do not use the appliance in the immediate vicinity of a bath, shower or swimming pool, but keep it at a safe
distance as set out by the CEE-CEI standards.
14. The appliance becomes very hot during use. Avoid all contact between your skin and the hot surfaces of the
appliance. Switch the appliance off and wait at least 5 minutes for it to cool down before performing any work on it.
15. Do not modify the appliance in any way.
16. Pay particular attention when used in unmanned environments.
17.Regularly inspect the appliance for visible defects. If any faults are found, do not operate the appliance but contact
Star Progetti Group immediately.
18. In order to avoid creating a fire hazard, the appliance must never be installed with the radiating elements close to
or facing towards curtains, beds or other objects or materials that are liable to burn easily; always ensure that these
objects are at a suitable minimum distance, to avoid any risk of fire or heat damage.
19. The appliance must be properly connected to an electrical system in compliance with the applicable regulations
and equipped with an efficient earthing system. If in doubt, have a qualified electrician perform a thorough check.
CLEANING
From time to time, remove dust from the disk and bulb using a clean brush or a jet of compressed air, so as to
guarantee that HELIOSA 993 provides maximum heating efficiency at all times.
6