Publicité
Les langues disponibles
Les langues disponibles
FR
FR
6. MANUAL OPERATION
ES
ES
• Press the 2000W button once for the high heat settings; press twice to switch off
the heat setting.
PT
PT
IT
IT
7. REMOTE OPERATION
EL
EL
• The standby switch located at the front right hand side above the fire must be
first switch on.
PL
PL
• It takes some time for the receiver to respond to the transmitter. Do not PRESS
RU
UA
the buttons more than once within two seconds for correct operation.
KZ
RO
1. Boot steps
1) Connect the power
EN
UA
2) Turn on the power switch
3)Press the " " key of the remote controller to start up
RO
4) Press the 1000W button for the 1000W heat settings; press twice to switch
off the heat setting.
BR
5) Press the 2000W button for the 2000W heat settings; press twice to switch
off the heat setting.
EN
6) Press the DIMMER button for operate the dimmer mode.
2. Room temperature control system with open window detection
1) Press the button " "or "F" on the fireplace, the heater will come into in the
working situation, open the heating function for some time.
2) Press the button "
".
3) When the fireplace heater detect the room temperature down suddenly, for
example, the window of the room is open, then the fireplace heater stop the
heating function, then the LED display showing of "
4) The heating function cannot operate during one hour by itself, but you can
press the button "
108
" on the remote control, the LED display will show "
" again, exit the open window detection function.
" will blink.
Publicité
