Machine Assembly; Assembling The Handle - Duplex STANDARD Instructions D'utilisation Et D'entretien

DUPLEX 340-420-620
1.5

MACHINE ASSEMBLY

The machine is shipped packed in cardboard
boxes (1).
On reception of the package, the user must
carry out the assembly of the parts which due
to their overall dimensions are unassembled
before being shipped.
The package contains the following:
•
Machine (2);
• Elbow for handle (3);
• Handle (4);
• Connecting casing (5);
• Use and maintenance manual (6);
•
Tanks (7);
• Certificate of Compliance.
1.6

ASSEMBLING THE HANDLE

1. Insert the elbow of the handle into the housing of the jointed elbow.
2. Tighten the two screws with the screwdriver supplied and tighten well (A);
3. Assemble the handgrip of the handle by pushing it through the connecting casing and make
sure to point the screws inward switch the cable-holder facing towards the bottom.
4. Screw up the three screws with the same screwdriver supplied (B)
4
A
54
2
5
6
3
Figure
B
Figure
1
7
1.4
1.5