Assembling The Machine; Disassembling The Handle - Duplex Nacecare TURBO Mop Manuel D'utilisation

DUPLEX TURBO
ASSEMBLING THE APPLIANCE
5.2

Assembling the machine

WARNING
Use the supplied hex wrench to assemble the handle as follows:
To assemble the handle, proceed as follows:
1) Insert the handgrip 1 into the handle 2
and fasten it using the plate 3 and the
screws 4.
2) Insert the handle 2 into the support 5
3) Insert the pin 6 into the support 5
4) fasten the handle 2 using the screws 7
by tightening them firmly.
5) Place the cap 8 into its seat on the tank 9.
6) Connect the suction hose 10 to the suction
recovery tank 11.
7) Insert the suction recovery hose 12 into
the hole 13 in the suction recovery tank 11.
5.2.1

Disassembling the handle

DANGER!
Make sure that the appliance
has been disconnected
from the battery before
disassembling the handle.
To disassemble the handle, follow the
assembly instructions in the reverse order.
3
7
7
5
98
1
4
2
10
11
12
13
6
11
9
8
F.33
Rev.
1.0