Duplex Nacecare TURBO Mop Manuel D'utilisation page 63

DUPLEX TURBO
MAINTENANCE
Does not start up
Does not start up
Vibrations during the work
stages
Sometimes the appliance
does not start given the
strong friction of the
brushes.
Scrapers left resting
on and stuck to the
conveyors by the dry
residual dirt deposited
from the previous cleaning
operation.
"Motor Protector" tripped
Faulty motor.
"Start&stop" button switch
tripped.
Battery fuse tripped.
Power cord plug not correctly
inserted into the battery.
Flat battery.
Warped brushes.
128
Lift slightly by tilting the
handle.
Lift the recovery tank and
clean the scrapers (see
section "7.3 Replacing the
scrapers").
Reset the appliance and re-
activate it by pressing the
MP button on the handle.
Reactivation occurs approx.
after 2 minutes.
Contact the Manufacturer.
Replace.
Remove the fuse cap on
the battery and replace
with an identical one of 16
Amp.
Do not use fuses
exceeding 16 Amp to avoid
serious risks.
If the fuse trips again,
search for the fault on the
appliance.
Restore.
Re-charge or replace with a
fully charged spare battery.
Replace.
Rev.
1.0