1Replacing The Brushes; 2Cleaning The Brushes - Duplex Nacecare TURBO Mop Manuel D'utilisation

7.2.1 Replacing the brushes
The appliance is fitted with a patented "trigger fitting" which enables the brushes to be
removed and replaced in a few seconds.
In case of wearing, warping or simply for replacement of the brushes with brushes more
suitable for the type of cleaning required, proceed as follows:
1) Remove the brushes 7 pressing the release device 10 (figure A).
2)
Fit the new or optional brushes (figure B).
7.2.2 Cleaning the brushes
Check the condition of the brushes 7 and if necessary, proceed as follows:
1) Remove the brushes 7 pressing the release device 10 (figure A).
2) Immerse them in a container of cold or lukewarm water and let them soak for a few
hours.
3) Stir and rinse well.
4) Refit the brushes reversing their original position. This is necessary as the bristles
tend to bend when the brushes always rotate in the same direction.
10
7
B
Rev.
1.0
A
10
7
121
DUPLEX TURBO
MAINTENANCE
7
7
F.52