Makita BO4900V Manuel D'instruction page 5

Place the punch plate (optional accessory) over the
paper so that the guide of the punch plate is flush with
the sides of the pad. Then press the punch plate to
make holes in the paper.
For hook-and-loop type of abrasive
paper with pre-punched holes
(optional accessory):
► 1. Hook-and-loop type of abrasive paper with pre-
punched holes 2. Pad for hook-and-loop type of
abrasive paper
Remove all dirt or foreign matter from the pad. Attach
the paper to the pad, aligning the holes in the paper with
those in the pad.
CAUTION:
• Never use pressure-sensitive abrasive paper.
For BO4901 only
NOTE:
• To use the hook-and-loop type of abrasive
paper, first replace the pad. Remove the pad for
the conventional type of abrasive paper from the
tool with a screwdriver.
Install the pad for the hook-and-loop type of
abrasive paper (optional accessory) on the tool.
Tighten the screws firmly to secure the pad.
2
1
► 1. Pad 2. Screws 3. Screwdriver
Installing paper dust bag
For BO4900, BO4900V only
Place the paper dust bag on the paper dust bag holder
with its front side upward. Insert the front fixing card-
board of the paper dust bag into the groove of the paper
dust bag holder.
1
1
2
► 1. Groove 2. Front fixing cardboard 3. Paper dust
bag
Then press the upper part of the front fixing card-board
in arrow direction to hook it onto the claws.
1
► 1. Claws 2. Upper part
Insert the notch of the paper dust bag into the guide of
the paper dust bag holder. Then install the paper dust
bag holder set on the tool.
3
► 1. Guide 2. Notch
5 ENGLISH
2
3
2
1
2