Dometic ACX3 Série Notice D'utilisation page 23

ACX3
There are no leaks at the connections if no bubbles form.
Disconnecting the cooler from the external gas supply
➤ Close the valve of the safety coupling of the gas port.
➤ Disconnect the hose line by pushing the sleeve towards the valve handle.
➤ Put the cap onto the safety coupling.
➤ Turn the cooling level controller (fig. 4 2, page 4 and fig. 5 2, page 5) anti-
clockwise as far as it will go (position "").
6.7 Connecting the cooler to a gas cylinder (ACX3 30 and
ACX3 40)
Note the following country-specific gas type and gas pressure categories:
Country
Denmark (DK), Finland (FI), Hungary (HU),
Norway (NO), Poland (PL), Sweden (SE)
Belgium (BE), Czech Republic (CZ), France (FR),
Italy (IT), The Netherlands (NL), Portugal (PT),
Slovakia (SK), Spain (ES), United Kingdom (GB)
Germany (DE), Austria (AT), Switzerland (CH),
Luxembourg (LU)
➤ Connect the ACX3 30 or ACX3 40 cooler to the gas hose (fig. 9, page 7) and
the gas cylinder (fig. 0, page 8).
A
NOTICE!
• After connecting the device to the gas supply, check the gas pipe for
leakage at all the connection points (all threaded connections, hose
connections with clamps, connection to the gas cylinder) using a
foaming agent, e.g. with soap.
• In addition, perform a visual inspection of the hose (for cracks,
weathering, damage).
• Replace any faulty hoses immediately with a new one.
EN
Device categories
I B/P – 30 mbar
3
I + – 28 – 30 / 37 mbar
3
I B/P – 50 mbar
3
Operation
23