Dometic ACX3 Série Notice D'utilisation page 16

Safety instructions
• If the device is left empty for long periods:
– Switch off the device.
– Defrost the device.
– Clean and dry the device.
– Leave the lid open to prevent mould developing within the device.
A
NOTICE! Damage hazard
• Check that the voltage specification on the type plate corresponds to
that of the energy supply.
• Only connect the cooling device as follows:
– DC outlet: Only use cables with an appropriate cross section.
– AC outlet: Only use the AC cable supplied
• Never pull the plug out of the socket by the cable.
• If the cooling device is connected to a DC outlet: Only select DC
operation (battery mode) if you are using a battery monitor or if the
alternator in your vehicle provides sufficient voltage.
• If the cooling device is connected to a DC outlet: Disconnect the
cooling device or switch it off when you turn off the engine. Otherwise
you may discharge the battery.
• The cooling device is not suitable for transporting caustic materials or
materials containing solvents.
• The insulation of the cooling device contains flammable cyclopentane
and requires special disposal procedures. Deliver the cooling device
at the end of its life-cycle to an appropriate recycling center.
• Do not use electrical devices inside the cooling device unless they are
recommended by the manufacturer for the purpose.
• Do not place the cooling device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
• Risk of overheating!
Always ensure sufficient ventilation so that the heat generated during
operation can dissipate. Make sure that the cooler is sufficiently far
away from walls and other objects so that the air can circulate.
Keep the following spaces (fig. 1, page 3).
• To enable the refrigerant to circulate properly, the cooler may not
tilted by more than 3°. Use a spirit level to make sure the cooler is level.
• Ensure that the ventilation openings are not covered.
• Do not fill the inner container with ice or fluids.
• Never immerse the cooling device in water.
• Protect the cooling device and cables against heat and moisture.
16
ACX3
EN