Makita SA5040C Manuel D'instructions page 6

ENGLISH
(Original instructions)
1 Shaft lock
2 Slide switch
3 Indication lamp (speed adjust-
ing dial)
4 Speed adjusting dial
5 Screw
6 Abrasive disc
7 Pad
8 Spindle
9 Head cover
10 Gear housing
11 Wheel guard
12 Bearing box
SPECIFICATIONS
Abrasive disc diameter
Wheel diameter
Max. wheel thickness
Spindle thread
Rated speed (n) / No load speed (n
Overall length
Safety class
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water. For
grinding and cutting-off, the correct wheel guards must
be mounted.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
6
Explanation of general view
13 Lever
14 Lock nut
15 Depressed center wheel
16 Inner flange
17 Lock nut wrench
18 Ezynut
19 Abrasive wheel
20 Arrow
21 Notch
22 Flex wheel
23 Plastic pad
24 Sanding lock nut
25 Rubber pad
Model
)
0
Net weight
(Depending on the optional wheel guard)
SANDER/GRINDER SAFETY WARNINGS
Safety Warnings Common for Grinding, Sanding,
Wire Brushing, or Abrasive Cutting-Off Operations:
1. This power tool is intended to function as a
ENE094-1
grinder, sander, wire brush or cut-off tool. Read
all safety warnings, instructions, illustrations
and specifications provided with this power tool.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury.
2. Operations such as polishing are not recom-
mended to be performed with this power tool.
ENF002-2
Operations for which the power tool was not
designed may create a hazard and cause personal
injury.
3. Do not use accessories which are not specifi-
cally designed and recommended by the tool
manufacturer. Just because the accessory can be
attached to your power tool, it does not assure safe
operation.
GEA010-1
4. The rated speed of the accessory must be at
least equal to the maximum speed marked on
the power tool. Accessories running faster than
their rated speed can break and fly apart.
5. The outside diameter and the thickness of your
accessory must be within the capacity rating of
your power tool. Incorrectly sized accessories can-
not be adequately guarded or controlled.
26 Marking A
27 Marking B
28 Marking C
29 Marking D
30 Abrasive cut-off wheel/diamond
wheel
31 Wheel guard for abrasive cut-off
wheel/diamond wheel
32 Wire cup brush
33 Wire wheel brush
34 Exhaust vent
35 Inhalation vent
SA5040C
125 mm
115 mm or 125 mm
6.4 mm
M14
–1
7,800 min
315 mm
2.2 kg
/II
GEB097-3