Operating Instruction - ROTOR Sanamat RSI Mode D'emploi

CH-3661 Uetendorf
7. OPERATING INSTRUCTIONS
- Place the collecting bowl.
- Place the centrifugal basket on the motor shaft and
rotate it slightly until it locks into place.
- Then screw in the screw in the center of the
basket and tighten it by hand with a clockwise rotation.
Do not hold the basket with your second hand, so that the
clutch engages automatically in the correct position.
NOTE!
The special screw to fasten the basket is small. Hence it must not be tightened
with too much force. Tightening it with force may damage the screw and prevent
the secure mounting of the sieve basket. For this reason, this screw must always
be screwed in by two fingers, as tightly as possible, without using tools. During
the extraction of the juice, the screw will tighten automatically a bit more. Loose the
screw with the groove in the plunger.
Instruction Manual
Rotor Sanamat RSI
=
=
© Rotor Lips AG
19