Dometic CE99-DF(HBG3445) Instructions De Montage Et De Service page 15

Hobs and Combinations
• Prior to installation, ensure that the local distribution conditions
(nature of the gas and gas pressure) and the adjustment of the device
are compatible.
• The adjustment conditions for this device are stated on the label.
• This device is not connected to a combustion products evacuation
device. It shall be installed and connected in accordance with current
installation regulations. Particular attention shall be given to the rele-
vant requirements regarding ventilation.
!
CAUTION!
• In case of safety glass cover breakage:
– Shut off immediately all burners and any electrical heating element
and isolate the device from the power supply.
– Do not touch the device surface.
– Do not use the device.
2.2 Safety when operating with gas
!
WARNING!
• Keep flammable substances away from heating and cooking devices,
and other light and heat sources.
• Suffocation hazard!
Before switching on the device, ensure that the area is sufficiently ven-
tilated. During operation, there must be air vents with a cross-section
of at least 23.25 in² (150 cm
be closed, but must be kept open when the device is operating (see
sign located above the device).
• Only operate the device at the pressure specified on the type plate.
Only use pressure regulators with a fixed setting that comply with the
national regulations.
• Compare the pressure information on the type plate with the pressure
information on the propane or butane gas cylinder.
• If you smell gas:
– Open all windows and leave the room.
– Do not operate any electrical devices or switches, and avoid using
open flames that can ignite the gas.
– Close the valve on the gas cylinder and keep it closed until the fault
has been rectified.
– Never attempt to find a gas leak with an open flame.
EN
General safety instructions
2
) in the installation space. These vents can
15