Answering An Incoming Phone Call From The Bluetube Speaker; Redialing Your Last Dialed Phone Number (Of The Paired Mobile Phone); Bluetooth Mode Options - PERFECTPRO Bluetube Manuel De L'utilisateur

Answering an incoming phone call from the Bluetube speaker

The Hands-Free-Calling feature allows you to answer an incoming phone call when operating in the Bluetooth or AUX-IN mode.
1. Press the Phone button ( ) on the right to pick up an incoming call from a paired mobile phone.
2. Speak towards the microphone (MIC) located under the Phone button of the Bluetube speaker.
3. Adjust the conversation volume by pressing the Volume – or + button. A lower volume setting can reduce a possible echo in
the phone conversation.
4. Press the Phone button ( ) again to end the phone call.
NOTE: The volume of the ringtone will be loudest for the first 20 seconds, next it will resume to the previous used level. Pressing the
Volume – or + buttons will also resume the volume to the previous used level.

Redialing your last dialed phone number (of the paired mobile phone)

The Hands-Free-Calling feature allows you to redial your last dialed phone number on your mobile phone (Bluetooth mode only).
1. Press the On/Off button to switch on the Bluetube speaker.
2. Select Bluetooth mode by pressing the Source / Lock button.
3. Press and hold the Phone button ( ) on the right for more than 2 seconds. The last dialed phone number on your mobile
phone will be redialed.
4. Adjust the conversation volume by pressing the Volume – or + button if necessary.
5. Press the Phone button ( ) again to end the phone call.
11

Bluetooth mode Options

The Bluetooth function can be set to operate in different ways:
1. In Bluetooth mode, press the Menu / Tone button to enter into the System setting.
2. Press the or button until "Bluetooth" is displayed; then press the Select / Info button.
3. Press the or button to select "BT always on", "BT mode only" or "Disconnect BT" options, and press the Select / Info
button to select the setting.
a. BT always on Bluetooth is turned on when the Bluetube speaker is on. You can playback music in the Bluetooth mode
and use the Hands-Free-Calling feature to answer incoming phone calls in all operation modes, for
example, also when you are listening to the Bluetube speaker. As an indication, the blue Bluetooth
connected LED will be on in all operation modes. (Bluetooth and AUX-IN).
b. BT mode only Bluetooth is turned on only in Bluetooth mode and not in the AUX-IN mode. You can playback music and
use the Hands-Free-Calling feature to answer incoming phone calls in the Bluetooth mode only.
As an indication, the blue Bluetooth connected LED will be on only in the Bluetooth mode.
c. Disconnect BT Bluetooth will be disconnected from your mobile phone and enter the "discoverable mode" (The blue
Bluetooth connected LED will start blinking until a new pairing is established). This to allow Bluetooth
pairing to another Bluetooth device. If no new device is paired, the Bluetooth will automatically try to
connect to the last paired device when it is switched off and on again.
The Auto-Power management function will be activated in Bluetooth mode. If there is "Not connected" for a period over 15 minutes,
the unit will automatically switch to standby mode. Pressing the On/Off button will "wake up" the unit again.
GB
12