Bosch Sensixx B22L Notice D'utilisation page 17

powerful shots of hygienic steam. Slowly iron
the whole garment to enhance the final result.
Notes:
• To ensure the high efficiency of the "Hygiene"
function, the system has to be reset after 20
minutes. Indicator light (9) blinks five times and
the steam generator switches automatically to
the "i-Temp" function.
• If desired to continue in the "Hygiene" function,
please turn the selector (10) to any other
setting. After that, you can choose again the
"Hygiene" function by turning the selector.
• Energy saving setting
while the "Hygiene" function is selected.
B. Setting the temperature
and steam amount

See the leaflet sides
1. Check the ironing instruction label on the garment
to determine the correct ironing temperature.
2. Choose one of the following settings :
Temperature Steam setting
•
••
•••
3. The indicator lamp (17) will remain lit while the
iron is heating and go out as soon as the iron
has reached the selected temperature.
4. The "steam ready" indicator lamp (9) will light
up after several minutes, indicating that steam
is ready to be released.
5. Press the steam release button (15-16*) to
release steam.
Tips:
• Sort your garments out based on their cleaning
symbol labels, always starting with clothes that
have to be ironed at the lowest temperatures.
• If you are not sure what the garment is made of
then begin ironing at a low temperature and
decide on the correct temperature by ironing a
small section not usually seen when worn
• At the beginning of each use, it is possible that
drops of water will be dispensed alongside
steam.
Therefore, it is advisable to try the iron on the
ironing board or a piece of cloth to start with.
"PulseSteam" function
This appliance has a special function for tackling
difficult creases.
The "PulseSteam" function helps soften stubborn
garments like jeans or linen faster.
cannot be activated
Suitable for
Synthetics
Silk – Wool
Cotton – Linen
When the steam release button is activated, the
steam generator will release three powerful shots
of steam so that the steam reaches even deeper
into the fabrics.
1. Set the setting selector (10) on "• ••"
2. Briefly press the steam shot button (16*) on the
top of the handle.
or (model dependent)
Press the steam release button (15) on the
bottom of the handle two times in quick
succession (double-click).
Remarks:
• It is possible to stop the shots of steam by
quickly pressing the steam button again.
• Some water drops may appear when you use
the "PulseSteam" function for the first time.
The water drops will disappear after you have
used the function for some time.
"IntelligentSteam" function
(Model dependent)
This system has intelligent steam control, which,
after releasing the steam release button (15),
provides a small amount of additional steam.
The additional steam can always be stopped by
briefly pressing the steam release button once
again.
Ironing without steam
Begin ironing but without pressing the steam
release button.
C. Vertical steam

See the leaflet sides
This can be used to remove creases from
hanging clothes, curtains etc.
Warning!:
E
Never direct the steam jet at garments
that are being worn.
Never aim the steam at people or
animals.
1. Set the temperature to the "•••" setting.
2. Hold the iron in an upright position 15 cm away
from the garment being steamed.
3. You can steam iron curtains and hanging
garments (jackets, suits, coats...) by placing the
iron in a vertical position and pressing the
steam release button (15 or 16*).
17
BOS CH