Haussmann Xpert HSMS15A-10-DB Mode D'emploi page 46

OPERATING INSTRUCTIONS
or similar solvent to remove the gum and pitch.
Unless you are experienced in sharpening
blades, we recommend you do not try.
Tool lubrication
Your tool has been properly lubricated and
is ready to use. It is recommended that tools
with gears be regreased with a special gear
lubricant at every brush change.
Periodically lubricate moving parts with a
silicone, or light oil spray. Do not use grease
because it tends to attract and hold sawdust.
CAUTION. Do not use powerful cleaning
agents to clean the plastic parts of the
tool.A mild detergent on a damp cloth is
recommended.Water must never come into
contact with the tool.
Carbon Brushes
The brushes and commutator in your tool
have been engineered for many hours of
dependable service.
To maintain peak efficiency of the motor,
we recommend every two to six months the
brushes be examined.
Only genuine replacement brushes
specially designed for your tool should be used.
Motor Brush Replacement
To inspect or replace brushes:
1. Unplug the saw.
Warning: The brush cap is spring loaded by
EN
the brush assembly.
2. Remove the brush cap on the motor using a
wide flat blade screwdriver.
3. Pull out the brush (B12). Repeat for the
opposite side.
NOTE: If installing the existing brush or
brushes, make sure the brush goes in the same
way it came out. Otherwise a break-in period
will occur that will reduce motor performance
and increase brush wear.
4. Inspect brushes for wear. On the wide flat
46
side of brush is a wear limit line. If the brush
contact face is at or beyond (no line visible) the
limit replace brushes as a set.
5. Install new brush.
6. Tighten the brush cap but do not
overtighten.
Drive Belt
The drive belt is a normal maintenance part
and should be inspected periodically for wear.
If the drive belt shows signs of drying out,
cracking or tearing, it should be replaced. If the
drive belt will not track properly or comes off
the pulleys, it should be replaced.
1. Installing new drive belt:
2. Loosen the screw and remove the drive belt
cover.
3. Cut and remove the worn drive belt (B13).
Before installing the new drive belt, clean both
pulleys thoroughly.
4. First place the new drive belt onto the drive
pulley, then rotate clockwise while pushing the
belt onto the driven pulley.
5. Reinstall the drive belt cover and securely
tighten screws.
General inspection
Before every operation of the mitre saw, check
and ensure the screw fastening the blade must
be tightened.
Regularly check that all the fixing screws are
tight.They may vibrate loose over time.