Haussmann Xpert HSMS15A-10-DB Mode D'emploi page 42

OPERATING INSTRUCTIONS
(not supplied) for the lock nut and the 6mm
hex key (not supplied) for the set screws.
Setting the fence square with the
table
1) Make sure that the electrical plug is removed
from the power point.
2) Push the saw arm(5) down to its lowest
position and engage the release knob (6) to
hold the saw arm in the transport position.
3) Loosen the mitre lock (25).
4) Rotate the table (21) until the pointer is
positioned at 0º.
5) Tighten the mitre lock (25).
6) Loosen the fence lock (45) which secure
the top sections (19A + 19B) of the fence and
remove these top sections.
7) Using the 6mm hex key, (not supplied)
loosen the four screws securing the fence (19)
to the base.
8) Place a square against the fence (19) and
alongside the blade.
9) Adjust the fence (19) until it is square with
the blade.
10) Tighten the screws securing the fence (19).
EN
11) Loosen the Philips head screw holding the
mitre scale pointer (22) and adjust it so that it
accurately indicates the zero position on the
mitre scale.
12) Retighten the screw securing the mitre
scale pointer (22).
13) Replace the top sections (19A + 19B) of the
fence and secure the fence lock (45). (B1)
Changing a blade
DANGER! Never try to use a blade larger than
42
the stated capacity of the saw. It might come
into contact with the blade guards.Never use a
blade that is too thick to allow the outer blade
washer to engage with the flats on the spindle.
It will prevent the blade screw from properly
securing the blade on the spindle.Do not use
the saw to cut metal or masonry.
Ensure that any spacers and spindle rings that
may be required suit the spindle and the blade
fitted.
1) Make sure that the electrical plug is removed
from the power supply.
2) Push down on the operating handle (7) and
pull the release knob (6) to disengage the saw
arm(5).The release knob (6) can be turned so
that it is held in the retracted position.
3) Raise the saw arm(5) to its highest position.
4) Using a Phillips head screwdriver loosen and
remove the screw and the spacer washer
that secure the guard retraction arm(13) to
the rotating blade guard (12). (B5) Swing the
guard upwards.
5) Using a Phillips head screwdriver loosen and
remove the screw that secures the blade bolt
cover (14). (B6)
6) Pull the rotating blade guard (12) down then
swing it up together with the blade bolt cover
(14).When the rotating blade guard (12) is
positioned over the upper fixed blade guard
(9) it is possible to access the blade bolt. (B7)
7) Hold the rotating guard (12) up and press
the spindle lock button (26).Rotate the blade
until the spindle locks.
8) Use the flange wrench (40) provided to
loosen and remove the blade bolt. (Loosen in a
clockwise direction as the blade screw has a
left hand thread). (B8)
9) Remove the flat washer and outer blade
washer and the blade. (B9)
10) Wipe a drop of oil onto the inner blade
washer and the outer blade washer where
they contact the blade.
11) Fit the new blade onto the spindle taking
care that the inner blade washer sits behind
the blade.