Haussmann Xpert HSMS15A-10-DB Mode D'emploi page 43

OPERATING INSTRUCTIONS
CAUTION. To ensure correct blade rotation,
always install the blade with the blade teeth
and the arrow printed on the side of the blade
pointing down.The direction of blade rotation
is also stamped with an arrow on the upper
blade guard.
12) Replace the outer blade washer.
13) Depress the spindle lock button (26) and
replace the flat washer and blade bolt.
14) Use the wrench (40) to tighten the blade
bolt securely (tighten in an anti-clockwise
direction).
15) Lower the blade guard,hold the rotating
lower blade guard (12) and blade bolt cover
(14) in position and tighten the fixing screw.
16) Replace the guard retraction arm and
secure onto the rotating blade guard.
17) Check that the blade guard operates
correctly and covers the blade as the saw arm
is lowered.
18) Connect the saw to the power supply and
run the blade to make certain that it is
operating correctly.
Cross-cutting (without slide action)
When cutting a narrow piece of wood it is not
necessary to use the slide mechanism. In these
cases ensure that the slide lock (29) is screwed
down to prevent the saw arm from sliding.
A crosscut is made by cutting across the grain
of the workpiece.A 90º crosscut is made with
the mitre table set at 0º.Mitre crosscuts are
made with the table set at some angle other
than zero.
1) Pull on the release knob (6) and lift the saw
arm(5) to its full height.
2) Loosen the mitre lock (25).
3) Rotate the mitre table (21) until the pointer
aligns with the desired angle.
4) Retighten the mitre lock (25).
WARNING.Be sure to tighten the mitre lock
before making a cut.Failure to do so could
result in the table moving during the cut and
cause serious personal injury.
5) Place the workpiece flat on the table with
one edge securely against the fence (19). If
the board is warped,place the convex side
against the fence. If the concave side is placed
against the fence, the board could break and
jam the blade.
6) When cutting long pieces of timber, support
the opposite end of the timber with the side
support bars (37), a roller stand or a work
surface that is level with the saw table.
7) Use the clamp assembly (10) to secure the
workpiece wherever possible.
8) It is possible to remove the clamp assembly
(10) by loosening the clamp assembly lock
(11) and moving it to the other side of the
table.
Make sure the clamp assembly lock is tight
before using the clamp.
9) Before turning on the saw, perform a dry run
of the cutting operation to check that there
are no problems.
10) Hold the operating handle (7) firmly.
Depress safety button (1) and squeeze the
switch trigger (24).Allow the blade to reach
maximum speed and slowly lower the blade
into and through the workpiece.
11) Release the switch trigger (24) and allow
the saw blade to stop rotating before raising
the blade out of the workpiece.Wait until the
blade stops before removing the workpiece.
Cross-cutting (with slide action)
When cutting wide workpieces,first unscrew
the slide lock (29).
EN
43