Haussmann Xpert HSMS15A-10-DB Mode D'emploi page 45

OPERATING INSTRUCTIONS
arm to its full height.
2) Loosen the mitre lock (25).
3) Rotate the mitre table (21) until the pointer
(22) aligns with the desired angle on the
mitre scale.
4) Retighten the mitre lock (25).
WARNING. Be sure to tighten the mitre lock
before making a cut.Failure to do so could
result in the table moving during the cut,
causing serious personal injury.
5) Loosen the bevel lock (16) and pull out the
0º bevel adjuster (18) and move the saw arm(5)
to the left or right to the desired bevel angle
(between 0º and 45º).Tighten the bevel lock
(16).
6) Place the workpiece flat on the table with
one edge securely against the fence (19). If
the board is warped,place the convex side
against the fence. If the concave side is placed
against the fence, the board could break and
jam the blade.
7) When cutting long pieces of timber, support
the opposite end of the timber with the side
bars (36), a roller stand or a work surface that
is level with the saw table.
8) Use the clamp assembly (10) to secure the
workpiece wherever possible.
9) It is possible to remove the clamp assembly
(10) by loosening the clamp assembly lock (11)
and moving it to the other side of the table.
Make sure the clamp assembly lock is tight
before using the clamp.
10) Before turning on the saw,perform a dry
run of the cutting operation to check that there
are no problems.
11) Hold the operating handle (7) firmly.
Depress safety button (1) and squeeze the
switch trigger (24).Allow the blade to reach
maximum speed and slowly lower the blade
into and through the workpiece.
12) Release the switch trigger (24) and allow
the saw blade to stop rotating before raising
the blade out of the workpiece.Wait until the
blade stops before removing the workpiece.
Maintenance and Cleaning
Service
Warning: Preventive maintenance performed
by unauthorized personnel may result in
misplacing of internal wires and components
which could cause serious hazard. We
recommend that all tool service be performed
by a Factory Service Center or Authorized
Service Station.
Cleaning
Warning: To avoid accidents, always disconnect
the tool from the power supply before cleaning
or performing any maintenance. The tool may
be cleaned most effectively with compressed
air. Always wear safety goggles when cleaning
tools with compressed air.
Ventilation openings and switch levers must be
kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects
through openings.
Check regularly to make sure the lower guard
and all moving parts are working properly.
Remove accumulated sawdust from working
parts by blowing with compressed air or
wiping with a damp cloth.
Caution: Certain cleaning agents and solvents
damage plastic parts. Some of these are:
gasoline, carbon tetrachloride, chlorinated
cleaning solvents, ammonia and household
detergents that contain ammonia.
Care of Blades
Blades become dull even from cutting regular
lumber.
If you find yourself forcing the saw forward to
cut instead of just guiding it through the cut,
chances are the blade is dull or coated with
wood pitch.
When cleaning gum and wood pitch from
blade, unplug the saw and remove the blade.
Remember, blades are designed to cut, so
handle carefully. Wipe the blade with kerosene
EN
45