Christopeit Sport CL3 Série Notice De Montage Et D'utilisation page 18

Step 3:
Installation of saddle (33) and saddle support (16).
1. Place the saddle (33) with the seat surface downwards.
2. Place the retaining plate of the saddle slide (34) on the upwards
pointing bottom of the saddle (33). The threaded pieces on the
bottom of the saddle (33) must project through the corresponding
holes in the retaining plate of the saddle slide (34).
3. Place washers (39) on the threaded pieces, screw on nuts (40)
and tighten firmly.
4. Place the movable seat slide (34) into the holder of saddle support
(16), set it at the desired horizontally position and tighten it by
washer (37) and hand grip nut (38).
5. Push the saddle support wrapping (73) onto the saddle support
(16). Insert the saddle support (16) into the provided holder of the
main frame (1) and secure at the desired position by screwing
in the saddle support screw (29). (Note: To screw in the saddle
support screw (29), the threaded hole in the main frame (1) and
one of the holes in the saddle support (16) must be aligned.
Furthermore, ensure that the saddle support (16) is not pulled
out of the main frame beyond the marked maximum adjustment
position. The setting of the saddle support can be adjust as
desired later.)
Step 4:
Installation of handlebar support (17) at main frame (1).
1. Place screws (14), spring washer (30) and washers (6) accessibly
beside the front part of the main frame (1).
2. Place the lower end of the support (17) against the main frame (1)
and plug the ends of the two computer cables (11+13) projecting
from (1) and (17) together.
(Note: The computer cable harness (13) projecting from the
support (17) must not slide into the tube, as it is required for
later steps of installation. When joining the tubes, ensure that
the cable connection will not trapped.)
3. Connect the tension cable of resistance control (25) to the bracket
of lower section cable of tension (12) (See figure A1-A3). Before
this step of the installation, it is advisable to adjust the resistance
setting to the position, at which the cable extends furthest from
the sheath. Put the lowest part of cable (19) into the small hook
of lower tension cable (12) (figure A1). Pull it until the small hook
get in higher position (figure A2) and then insert the cable (25)
onto the bracket (12) (figure A3). When joining the tubes, ensure
that the cable connection is not trapped.
4. Push the handlebar support (17) onto the main frame (1) and put
one washer (6) and one spring washer (30) on each screw (14).
Push the screws (14) through the holes in the support (17), screw
into the threaded holes of the main frame (1) and tighten firmly.
18