Christopeit Sport CL3 Série Notice De Montage Et D'utilisation page 19

Step 5:
Installation of handlebar (27) at handlebar support (17).
1. Place the handlebar (27) against the handlebar support (17)
and adjust so that the hole patterns in the handlebar and the
handlebar support are aligned. Put one spring washer (30) and
washer (39) on each screw (31).
Push the screws (31) through the holes in the support, screw
into the threaded holes of the support (17) and tighten firmly.
2. Push the hand pulse cable (28) thought the holes into the top of
handlebar support (17).
3. Cover the handle bar connection with handlebar cover (32).
Step 6:
Installation of the computer (24) at handlebar support (17).
1. Take the computer (24) that has been supplied out of the pak-
kaging and insert the batteries (Type "AAA"-1.5 V pencells) by
watching for the right polarity on the back of the computer (24).
(Batteries for the computer are not included in this item. Please
buy them at your located market.)
2. Guide the computer (24) to top of the upper handlebar support
(17) and connect the plugs of upper connection cable (13) and
pulse cables (28) with computer cables.
3. Push the computer (24) with computer (8) onto the top of upper
handlebar support (17) and fix it with screws (21) and washers
(22).
19