Gaggenau VL 414 111 Notice De Montage page 12

3 Using the screws included, bolt down the control
panel on the bracket.
9
CAUTION
Appliance damage! Establish equipotential
bonding. Before the control cables may be
plugged onto the control panel, the stranded
grounding wire from the control unit must be
fitted on the control panel.
12
Install Appliance
9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
1 Plug the control cable into the socket on the control
desk. The plug must snap into place.
2 Shorten the front clamp relative to the countertop
thickness . Break the metal sheets off at the
predetermined breaking points.
Note: Make sure that you do not shorten it too
much, the clamping effect to the countertop must
be guaranteed.