Trouble Shooting - FLORABEST FHL 900 D4 Traduction Des Instructions D'origine

GB IE

Trouble Shooting

Problem
Device does not start
Device runs with inter-
ruptions
Blades become hot
14
Possible cause
Mains voltage not on
On/Off switch (13) defective
Worn carbon brushes
Defective motor
Power cable is damaged
Internal loose electrical
connection
On/Off switch (13) defective
Blades (1) are blunt
Blades (1) are notched
Too much friction due to lack
of lubrication
Fault correction
Check plug socket, cable, line
and plug, where appropriate,
have repaired through electrical
specialist
Repair by Service Centre
Check the cable and have it
changed by the Service Centre if
necessary
Repair by Service Centre
Have the blades (1) sharpened or
replaced (Service Centre)
Have the blades (1) checked or
replaced (Service Centre)
Oil the blades (1)