Trouble Shooting; Fault Correction - FLORABEST FHL 900 E5 Traduction Des Instructions D'origine

Trouble Shooting

Problem
Device does not start
Device runs with in-
terruptions
Blades become hot
Possible cause
Mains voltage not on
A
On/Off switch (
defective
Worn carbon brushes
Defective motor
Power cable is damaged
Internal loose electrical
connection
A
On/Off switch (
defective
A
Blades ( 1) are blunt
A
Blades ( 1) are notched
Too much friction due to
lack of lubrication

Fault correction

Check plug socket, cable, line
and plug, where appropriate,
have repaired through electrical
specialist
17)
Repair by Service Centre
Check the cable and have it
changed by the Service Centre
if necessary
Repair by Service Centre
17)
Have the blades (
sharpened or replaced (Service
Centre)
Have the blades (
or replaced (Service Centre)
Oil the blades (
GB
IE
A
1)
A
1) checked
A
1)
35