Trouble.shooting; Spare.parts; Fault.correction - FLORABEST FHT 600 B2 Traduction Du Mode D'emploi D'origine

GB
Trouble Shooting
Problem
Device does not start
Device runs with inter-
ruptions
Blades become hot
Spare Parts
Replacement parts may be ordered directly from our Service Centre (see p.50).
When ordering, always specify the machine type and the part number in the exploded draw-
ing.
Item 18 (Exploded Drawing) ...........Hand protection ....................Product No. 91092221
48
Possible.cause
Mains voltage not on
On/Off switch (
defective
Worn carbon brushes
Defective motor
Power cable is damaged
Internal loose electrical
connection
On/Off switch (
defective
Blades are blunt
Blades are notched
Too much friction due to
lack of lubrication

Fault.correction

Check plug socket, cable, line and
plug, where appropriate, have re-
paired through electrical specialist
6)
Repair by Service Centre
Check the cable and have it
changed by the Service Centre if
necessary
Repair by Service Centre
6)
Have the blades (
or replaced (Service Centre)
Have the blades (
replaced (Service Centre)
Oil the blades (
2) sharpened
2) checked or
2)