Renfert MTplus Mode D'emploi page 26

Dry Trimming:
Fault
Disc buildup.
Excessive dust
being blown out
of the grinding
opening.
EN
Possible cause
• Models are too wet.
• Extraction not switched on.
• Insufficient suction.
• Extractor or dust bag full.
• Extractor hose blocked.
• Clean the disc with a brush
under running water or with
plaster solvent (Renfert GO-
2011 Art. No. 2011-0000).
• Switch the extraction on.
• Increase the suction.
• Replace the dust bag.
• Check/clean the hose.
- 10 -
Corrective action
Subject to modification.