Setting The Preset Time - Harvia SENTIO pronet Instructions D'installation Et Mode D'emploi

Instructions for installation and use

8.3. Setting the preset time

WARNING!
Risk of fire
Combustible objects that are placed on the sauna heater could ignite
and cause fires.
● NEVER place combustible objects on the sauna heater.
● Make sure that NO combustible objects have been placed on the
sauna heater before the sauna control unit is switched on.
To start the sauna control unit with time-delay or at a specific time, a preset time
must be set under the menu item Timer. The required functions must be activated
beforehand. To do so, proceed as follows:
1. Use the Sauna/Humidity menu to set the preferred settings for the sauna
and humidity.
2. Switch the functions to ON
► The sauna heater temporarily starts heating.
3. Once all settings have been made, switch to the Timer menu.
4. Now set the preferred preset time in hours and minutes under the Preset time
item (observe that this is the period of time until the control unit switches on).
5. Press Start
► All functions started beforehand are stopped. The preset time is now
active and the remaining time is shown in the main menu, as shown in
the following figure:
► Example:
► Once the time displayed has elapsed, the previously selected
functions start.
► Clicking on this window automatically redirects you to the timer
menu.
Preset time: 03 h 08 min
p. 21/26
EN