Sharp LL-T2020 Mode D'emploi page 12

Connecting the monitor and turning the monitor on and off
Analog connection
Connect the analog signal cable to the analog RGB
output terminal of the computer.
Analog signal cable
- Paying attention to connector direction, firmly
insert the signal cable to terminal, and then
tighten the screws at both sides.
If connecting to a D-sub 15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal cable.
Macintosh conversion adapter
Note:
- If connecting to the Sun Ultra series, a
conversion adapter (commercially available) may
be required.
Digital connection
Connect the digital signal cable to the digital RGB
output terminal of the computer.
- For digital RGB connection, the monitor has an
input for connecting to a computer with a DVI-
compatible output connector (DVI-D 24 pin or
DVI-I 29 pin) and UXGA output capability.
(Depending on the type of computer to be
connected, the display may not work correctly.)
- Use the accessory digital signal cable or an NL-
C04J cable (sold separately).
If using other commercially available digital
signal cables, correctly display may not be
achieved. UXGA resolution may not be available
when using the NL-C01E digital signal cable.
Input terminal 1 and 2
You can connect to
either side.
Analog RGB output
terminal
Digital signal cable
- Paying attention to connector direction, firmly
insert the signal cable to terminal, and then
tighten the screws at both sides.
Set the monitor as follows when establishing a
digital connection with a Power Mac using an ADC-
DVI adapter made by Belkin. (Operation has been
checked with the Power Mac G4 M7627J/A)
- Perform settings with the Power Mac power
supply off.
1.After connecting the power cord, turn on the
monitor's main power.
2.Press the button and
and while doing this press the POWER button
(i.e. turn the power on).
M AC D I G I TA L
I N P U T- 1
I N P U T- 2
3.Set the input terminal to which the Belkin ADC-
DVI adapter is connected to ON.
Use the button to select [INPUT1] or
[INPUT2], and use the
[ON] and [OFF].
- Do not set to [ON] if you are not using a Belkin
ADC-DVI adapter, as this may result in
incorrect display.
4.Press the power button, and turn off the monitor
power.
This completes setting.
12
Input terminal 1 and 2
You can connect to
either side.
Digital RGB output
terminal
button simultaneously,
O F F O N
O F F O N
buttons to select