Remote Control Unit; Remote Control Unit (Rc-933) - Denon UD-M31 Mode D'emploi

ENGLISH
Presetting or naming radio stations
(This operation is only possible from the remote control unit.)
You can preset up to 40 FM/AM stations.
You can name the preset stations (up to 8 characters each).
1
Tune in the desired preset station.
Press the EDIT button on the remote control unit.
2
• You can now begin character input.
Press the +/– button until the desired character
appears on the display. Press the ENTER/MEMORY
button on the remote control unit to store the input
character.
• Press the 7 button or the ENTER/MEMORY
3
button to store the input character. The cursor will
move to the next character space. Repeat step 3
until all the characters have been stored.
• You can move the cursor backward by pressing
the 6 button to make corrections.
Press the EDIT button to confirm the names of the
preset stations.
4
• The preset number is displayed. "MEMO" and
"P. SET" indicator flashes for 10 seconds.
Press the +/– button on the remote control unit to
5
tune in the desired preset number.
Press the ENTER/MEMORY button to confirm the
6
preset station number.
• To discontinue the procedure, press the CLEAR button on the remote control unit before proceeding to step 4.
• To erase a preset station name, press the PRESET •/ª to display the preset station you want to erase, then press
EDIT and CLEAR. The preset station name is erased, and only the preset frequency appears on the display.
• To preset only the frequency of the radio station, start over from step 1. Then press the ENTER/MEMORY button and
proceed to steps 5 through 6. The display shows the preset number, band and frequency.
12
EDIT
Flashes
PRESET
- +
ENTER/MEMORY
ENTER
MEMORY
Next flashes
EDIT
Flashes
PRESET
+
-
Flashes
ENTER
MEMORY
Listening to Preset Stations
(This operation is only possible from the remote control unit.)
The preset stations can be recalled using the number buttons on the remote control unit.
Also, if the following operation is performed when the system power is off, the power automatically turns on and the
radio is played. (Auto on function)
Example: Listening to the station preset at number 3
1
Press the TUNER button on the remote control unit.
2
Press button "3" on the remote control unit.
• When the station name appears in the display, each press of the PANEL button on the remote control changes the
display between preset number, band, and frequency.
TUNER
When the station name is preset,
3
station name is displayed.