Listening To Radio Programs - Denon UD-M31 Mode D'emploi

9

LISTENING TO RADIO PROGRAMS

Auto tuner presets
Use this to automatically search for FM broadcasts and store up to 40 stations at preset channels 1 to 40.
NOTE:
• If an FM station cannot be preset automatically due to poor reception, use the "Manual tuning" operation to tune
in the station, then preset it using the manual "Preset memory" operation.
CD RECEIVER UD-M31
ON / STANDBY
1
Press the power operation switch to turn on the
1
power.
Press the FUNCTION button to select TUNER
2
mode.
Press the BAND button to select the FM AUTO or
3
the FM MONO.
Press the MENU/SET button for at least 2 seconds.
• "A PRESET", "CANCEL –" and "START +"
4
appear alternately on the UD-M31's display.
• Press the – button to cancel.
Use the + button to select "START".
• "SEARCH" flashes on the display and searching
begins.
5
• The TUNER function display reappears once
searching is completed.
• If you want to stop searching, press the – button.
(Check the connections on Pages 6.)
3
BAND
- +
MENU / SET
TONE/SDB
VOLUME
FUNCTION
PHONES
2 4 5
ON / STANDBY
FUNCTION
BAND
MENU / SET
+
Manual tuning
CD RECEIVER UD-M31
ON / STANDBY
1
Example: Tuning in FM 92.50 MHz
(AM stations are tuned in using the same procedure.)
Press the power operation switch to turn on the
1
power.
Press the FUNCTION button to select TUNER
2
mode.
Press the BAND button on the tuner to select the
3
FM AUTO.
Use the Tuning +/– button to tune the frequency to
✽
92.50. Once the frequency is tuned in, adjust the
4
volume to the desired level using the VOLUME
control.
✽ The function of the +/– button on the main unit may toggle between Tuning +/– and Preset +/– functions.
• Pressing the – button while holding down the BAND button at the same time changes function of the +/– button to
Tuning +/–. ("TUNING" flashes for 5 seconds.)
• Pressing the + button while holding down the BAND button at the same time changes the function of the +/– button
to Preset +/–. ("PRESET" flashes for 5 seconds.)
• The +/– button is factory preset to function as a Tuning +/– button.
However, be sure that the +/- buttons function as the Tuning +/– button before proceeding with step 4.
Auto Tuning
• When a program being broadcast in stereo is received, the "ST" indicator lights and the program is received in stereo.
• If reception is poor and there is much noise in the stereo signals, press the BAND button to set the FM MONO mode.
• When one of the Tuning +/– button is pressed, the frequency changes in steps of 100 kHz in the FM band, 10 kHz in
the AM band.
• If one of the Tuning +/– button is held for over 1 second, the frequency continues to change when the button is
released (auto tuning) and stops when a station is tuned in. Tuning will not stop at stations whose reception is poor.
• To stop the auto tuning function, press the Tuning +/– button once.
NOTE:
• A humming sound may be heard when using a TV nearby while receiving AM programs. If this happens, move the
system as far from the TV as possible.
ENGLISH
3 4
BAND
- +
MENU / SET
TONE/SDB
VOLUME
FUNCTION
PHONES
2
ON / STANDBY
FUNCTION
BAND
This lights when a station is tuned in.
- +
11