Siren Module - Elkron HPA700M Notice D'installation

Wall
fastening
hole
Pre-setting for
protection module
Battery
housing
Cables
passage
piercing
arrangem.
Wall
fastening
hole

3.0 SIREN MODULE

+B Positive battery (connected at the factory)
-B
Negative battery (connected at the factory)
+ Supply positive
- Supply negative
Alarm input. Programmable NC or double balanced (6K8 – 5%) referred to positive or negative
AL
System status input. Programmable NC or double balanced (6K8 – 5%) referred to positive or negative.
S
To ensure compliance with the standard, it should be closed to the chosen reference.
TA
TAMPER contact output terminal (normally closed)
TA
F
Failure output: it supplies a positive which, however, is lost in the event of a failure
D Data line for the protection module (if present)
+P Positive available for protecting module supply (if present)

TAMPER-type connector for connection of the anti-
opening/anti-removal microswitch

AP connector for speaker connection

DEMO jumper for listening to the 8 siren sound
modes and/or checking the fault codes
25/44
Drilled riser
for securing
internal cage
Wall
fastening
hole
Drilled riser
for securing
external
cover
Drilled risers
for securing
internal cage
HPA700M