Bosch Zamo Notice Originale page 38

38 | English
measuring button until you have done this.
If the tape is already extended when you are fitting the adapter
to the measuring tool or switching on the measuring tool, the
"roll in" indicator will appear on the display. Retract the tape
fully and press the measuring button before taking a new
measurement.
Always make sure that the measuring tape does not
u
snap back into the adapter. Release the tape slowly back
into the adapter; otherwise it may become damaged.
Area measurement
– Press the measuring button (1) twice in quick succession to
multiply the last two measurements together. The indicator
appears on the display and the area measurement is
shown.
Digital laser measure with wheel
adapter
Operation
– Switch on the measuring tool (see "Switching the laser
measure on/off", page 33).
Measuring Length (see figures K1−K2).
– Run the wheel (15) along the distance to be measured.
After the measuring tool has been switched on, the wheel
measures continuously. The current measured value (g) is
shown on the bottom line of the display.
During continuous measurement, the wheel can be moved
forwards or backwards. The measured values will be posit-
ive in both directions. If the direction is changed during the
measurement, the value will be deducted until the starting
point (zero point) has been reached. Once the starting
point has been crossed, the value will become positive
1 609 92A 454 | (14.06.2018) Bosch Power Tools