Reassembling The Angled Screwdriver - KLS Martin group Angulus2 Mode D'emploi

Instructions for Use
Angulus2 Angled Screwdriver
Ensure that the angled screwdriver is completely dry, both inside and out, following thermo
•
washer disinfection.
Remove any liquid residues using compressed air (maximum operating pressure of 3 bar).
•
• Oil the dry angled screwdriver immediately after thermodisinfection.
6.2.5

Reassembling the Angled Screwdriver

Reassemble the angled screwdriver after manual and mechanical cleaning and disinfection.
•
NOTICE
Risk of material damage!
All 3 EN (serial numbers) must match. Possible damage to products in the case of a failure to
comply.
• Insert the head into the sheath until it engages.
Pay attention to the symbols and turn from
•
Revision 04
to until it locks.
51