Settings - Wilo RAIN3 Série Notice De Montage Et De Mise En Service

en
a
b
a
b
c
6.4

Settings

a
Menu no. Parameter /
info
Setpoints
1.00
MP start
1.04
threshold
MP stop
threshold
1.05
MP stop
delay
1.06
CP start
1.18
time
CP stop time -60
1.19
32
Description
a : Setting
c
b : Information Wilo-RAIN3
c : Running mode (Auto - Manual)
d : Supply mode (Rainwater - City main water)
d
If the touchscreen is active:
d
a : This icon allows modifying the delivered operating pressure
b : Pump is working
c : Pump stopped
d : This icon allows selecting the following mode (Auto - Manual - Stop)
e
e : This icon will force the use of the city main water
f
f : This icon will force the use of rainwater
The settings menu allows adjusting the pressure in the system and choosing between
several functions and setups. It also permits to see the installation parameters, the run-
ning time, etc.
In case of an error (alarm active), the touchscreen turns red. Once the problem is solved,
it is necessary to do a "reset" on the touchscreen to return to the normal mode. The
values can be changed with the up and down arrows:
Setpoint menu example:
b
a : Selection of parameter to be adjusted - Go back to another menu level
c
b : Navigation line
c : Navigation scroll up and down
Menus and submenus
MP : Main pump HiMulti3
CP : Cirstern pump
TWM : Tap water mode
RWM : Rainwater mode
Min. Max. Text
75 99
1.0 4.9
1.0 4.9
1 120
+60
Default Unit Ac-
cess
level
1
90 % 2
1.2 bar 1
3.5 (HiM- bar 1
ulti3-24)
4.4 (HiM-
ulti3-25)
4.9 (HiM-
ulti3-45)
20 s 2
+2 s 2
Description
Sub menu for values related to the set-
ting of the setpoint
Start threshold relative to setpoint for MP
Stop threshold relative to setpoint for
MP. The value depends on selected curve
in menu 5.04; Setpoint should be least
0,5bar higher than the start threshold
pressure
The delay to stop a pump after stop
threshold is reached and current value
stays above
Start time related to start of MP
Stop time related to start of MP
WILO SE 2019-10