Controller Interface; Settings - Wilo RAIN3 Notice De Montage Et De Mise En Service

6.3

Controller interface

a
b
a
b
c
6.4

Settings

a
Installation and operating instructions Wilo-RAIN3
Description
Wilo-RAIN3 is equipped with a LCD touchscreen to monitor the rainwater utilisation
and set the system parameters according to the needs.
Screensaver (if no action on touchscreen after 30 seconds):
a : Setting
c
b : Information Wilo-RAIN3
c : Running mode (Auto - Manual)
d : Supply mode (Rainwater - City main water)
d
If the touchscreen is active:
d
a : This icon allows modifying the delivered operating pressure
b : Pump is working
c : Pump stopped
d : This icon allows selecting the following mode (Auto - Manual - Stop)
e
e : This icon will force the use of the city main water
f
f : This icon will force the use of rainwater
NOTICE
If the symbol is visible, Drives are "OFF". It will be necessary to activate it in
menu 3.01 in chapter 6.4
The settings menu allows adjusting the pressure in the system and choosing between
several functions and setups. It also permits to see the installation parameters, the run-
ning time, etc.
In case of an error (alarm active), the touchscreen turns red. Once the problem is solved,
it is necessary to do a "reset" on the touchscreen to return to the normal mode. The
values can be changed with the up and down arrows:
NOTICE
There are 3 levels of menus. By default level 1 is activated. In order to modify para-
meters from other levels, it will be necessary to unlock them in chapter 7.01. If no
action after 6 minutes, the system will be switched again to level 1. Level 3 is re-
served to Wilo after-sale service.
Setpoint menu example:
b
a : Selection of parameter to be adjusted - Go back to another menu level
c
b : Navigation line
c : Navigation scroll up and down
Menus and submenus
MP : Main pump HiMulti3
CP : Cistern pump
TWM : Tap water mode
RWM : Rainwater mode
en
33