Spare Parts; Disposal - Wilo RAIN3 Notice De Montage Et De Mise En Service

Incidents
Dry running RWM
Dry running TWM
11

Spare parts

12

Disposal

Installation and operating instructions Wilo-RAIN3
Spare parts
Error codes Causes
E62.1 No minimum pressure after
MP start/operation within a
specific time in RWM
E62.2 No minimum pressure after
MP start/operation within a
specific time in TWM
If a failure persists or cannot be solved, please contact a specialist or the nearest Wilo
after-sales service.
Contact a local retailer and/or the Wilo after-sales service to order spare parts.
Mention the article number of the system on the rating plate for a rapid processing of
the order or service request.
Information on the collection of used electrical and electronic products.
Proper disposal and appropriate recycling of this product prevents damage to the envi-
ronment and dangers to your personal health.
NOTICE
Disposal in domestic waste is forbidden!
In the European Union, this symbol can appear on the product, the packaging or the
accompanying documentation. It means that the electrical and electronic products
in question must not be disposed of along with domestic waste.
To ensure proper handling, recycling and disposal of the used products in question,
please note the following points:
ƒ
Only hand over these products at designated, certified collecting points.
ƒ
Observe the locally applicable regulations! Please consult your local municipality, the
nearest waste disposal site, or the dealer who sold the product to you for informa-
tion on proper disposal. For further information on recycling, go to www.wilo-recyc-
ling.com.
Self-acknow- Following actions
ledging
x If within in specific time there is no min-
imum pressure. The pump keeps on run-
ning and it will be switched over to TWM
for an adjustable time and back again in
RWM. If pressure is increase above min-
imum pressure within an adjustable time
in RWM, system operates normally again.
If pressure could not increases, it will be
switch over to TWM and back again for a
maximum of 5 times per hour. During this
time the pressure value on main screen is
blinking. After 5 times pump stops, error
will be generated.
x Pump stops, error will be generated.
en
45