Assembly Instructions With Exploded Diagrams - Christopeit Sport AX 2 Notice De Montage Et D'utilisation

Assembly Instructions
Remove all the separate parts from the packaging, lay them on the floor
and check roughly that all are there on the base of the assembly steps.
Please note that a number of parts have been connected directly to
the main frame and preassembled. In addition, there are several other
individual parts that have been attached to separate units. This will make
it easier and quicker for you to assemble the equipment.
Step 1:
Attach the stabilizer (7) + (21) at main frame (44).
1. Attach the front foot (7) with the preassembled transport rollers (6) to
the main frame. Do this with the two screws (22), washers (4), spring
washers (36) and cap nuts (37).
2. Attach the rear foot (21) with eccentric caps (20) to the main frame. Do
this with the two screws (22), washers (4), spring washers (36) and cap
nuts (37). After assembly has been completed, you can compensate
for minor irregularities in the floor by turning the eccentric cap (20). The
equipment should be set up that the equipment does not move of its
own accord during a training session.
Step 2:
Attach the pedal (12L+12R) at pedal crank (68L+68R).
1. Screw the right pedal (12R) into the locator in the right-hand side (as
seen in operation) for the pedal crank (68R) (warning! the screw direction
is clockwise).
2. Screw the left pedal (12L) into the locator in the left-hand side (as seen
in operation) for the pedal crank (68L)
(Warning! the screw direction is anti-clockwise).
3. Then mount the pedal straps left and right on the associated pedals
(12). (The pedals are signed with "L" for Left and "R" for Right.)
19