Assembly Instructions With Exploded Diagrams - Christopeit Sport AP 1 Notice De Montage Et D'utilisation

Assembly Instructions
Remove all the separate parts from the packaging, lay them on the floor
and check roughly that all are there on the basis of the following assem-
bling steps. Please note that a number of parts have been connected
directly to the main frame and preassembled. In addition, there are
several other individual parts that have been attached to separate units.
This will make it easier and quicker for you to assemble the equipment.
Step 1:
Attach the stabilizer (54 + 58) at main frame (26).
1. Attach the front foot (54) with the preassembled transport rollers (53) to
the main frame. Do this with the two screws (56), spring washers (21),
washers (17), and cap nuts (55).
2. Attach the rear foot (58) to the main frame (26). Do this with the four
screws (16), spring washers (21), and washers (42). After assembly has
been completed, you can compensate for minor irregularities in the
floor by turning the wheel at cap (57). The equipment should be set up
that the equipment does not move of its own accord during a training
session.
Step 2:
Attach the front post (13) at main frame (26).
1. Hold the handlebar support (13) with the computer cable (7) against the
main frame holder. Connect the plug for the computer cable (7) coming
out of the bottom of the handlebar support (13) of the computer with
the matching plug for the sensor cable (24) coming out of the main
frame (33). (Note: The computer cable harness (7) projecting from the
support (13) must not slide into the tube, as it is required for later steps
of installation.)
2. Connect the cable of tension control (12) to the bracket of lower section
cable tension (25) (See figure A1-A4). Before this step of the installation,
it is advisable to adjust the resistance setting to the stage, at which the
cable extends furthest from the sheath. Put the lowest part of cable (12)
into the small hook (figure A1). Pull it (figure A2) until the small hook get
in higher position and then insert the cable (12) onto the bracket (25)
(figure A3+4).
3. Place the handlebar support (13) in the locator provided for it in the
main frame (26). Ensure that the cable connections are not squashed.
When putting the steering tube in place, push the former slowly down
into the locator in the main frame. Screw the handlebar support (13)
onto the base frame (26) with the screws (16), spring washers (21) and
washers (17).
15