Gallagher SmartPower MBX1500 Notice D'installation page 8

Installation Guide
Step 3: Connect the fence
a) Connect the energizer's red Output ( ) terminal to the fence using Underground Cable (G6270).
b) Attach the other end of the cable to the fence using a Joint Clamp (G6030).
For instructions on fence installation see the Gallagher Power Fence™ Manual enclosed.
If you wish to use the Fence Voltage information see the section "Understanding your SmartPower
Note:
Energizer: Fence Voltage and Alarm".
Step 4: Turn the Energizer on
a) Plug the energizer into a power outlet and switch ON.
b) Allow at least 15 pulses for the energizer to adapt to the fence system.
Note: Readings will change as your SmartPower Energizer responds to fence conditions.
This is the energizer monitoring the fence and adapting its power output accordingly.
Read the sections "Understanding your SmartPower Energizer" pages 7-8 for a complete understanding of the
displays and alarms.
We recommend the earth system is tested after installation as per the "Earth Test" in the "Earth Voltage and Alarm"
section (pg 8).
Installation Error
If the Output and Earth terminals have been connected the wrong way around the energizer will display the reading
E7. If this occurs re-connect the terminals correctly.
Keep the Quick Reference Help Guide beside your energizer.
+ -
For Mains Operation with Battery Back-up and for Battery Only Operation
:
IMPORTANT
included). Plug the battery leads into the back of the energizer before mounting the energizer. The red
lead must be next to the (+) symbol and the black lead next to the (-) symbol on the back of the energizer.
Step 1: Install the Energizer, connect to earth and fence
Follow Steps 1-3 described on the previous page.
Step 2: Connect the battery
Connect the battery leads from the energizer to the battery: red lead to the (+) terminal of battery, black lead to the
(-) terminal of battery. If connecting more than one battery, connect the batteries in parallel.
Only use a 12V battery which is suited to back-up or cyclic applications (eg. G5180). The recommended type is a 12V
deep cycle lead acid rechargeable battery.
:
IMPORTANT
OFF from the mains before connecting or disconnecting the battery.
+ -
For mains operation with battery back-up:
Follow Step 4 (Turn the energizer on): described above. When connected to mains power, the energizer trickle
charges the battery. In the event of mains power failure, the energizer will automatically switch to battery back-up
and continue to power the fence.
+ -
For battery only operation:
Follow Step 4 (Turn the energizer on): from Step b) described above.
For more information about operating SmartPower with a battery, see "Battery Use" section (pg 10).
8
To connect the battery, you will need to use the Gallagher MBX Battery Lead (G5740, not
When you connect up the battery, the energizer will start working. Ensure energizer is turned
Gallagher 3E0795 SmartPower MBX User Manual Gallagher 3E0795 SmartPower MBX User Manual