Gallagher M1800i Notice D'utilisation page 14

Using The Energizer Controller
Energizer Voltage and Alarm
The energizer output is the default screen display mode. The zone indicator arrow
is highlighti ng the energizer zone (
this case.
The quickscan bargraph display is also indicati ng an output voltage of over 7KV.
If the energizer output voltage falls below the alarm level (default 3KV) then the
status LED will fl ash red, the energizer zone indicator will become highlighted and an
internal buzzer will sound on the energizer. The buzzer can be muted by pressing any
key on the controller, except when there is a sudden increase in fence load. In this
situati on the buzzer will ti me out aft er 15 minutes (if the energizer has not already
been turned off ).
12
Gallagher 3E2489 M1800i M2800i Energizer User Manual
) and the energizer output voltage is 7.3KV in
Controller showing the energizer operati ng normally
Controller showing the energizer in output alarm