Milwaukee M12 BI Notice Originale page 15

TECHNICAL DATA
Inflator
Production code
Battery voltage
Input power
Max. pressure
Air delivery rate
@ 0 psi / 0 bar / 0 kPa
Air delivery rate
@ 35 psi / 2,41 bar / 241 kPa
Recommended Ambient Operating
Temperature
Recommended battery types
Recommended charger
Pressure hose length
Weight without battery
Weight according EPTA-Procedure
01/2003(Li-Ion 2,0 ... 6,0 Ah)
WARNING Read all safety warnings, instructions,
illustrations and specifi cations provided with this power
tool. Failure to follow the warnings and instructions may result in
electric shock, fi re and/or serious injury.
Save all warnings and instructions for future reference.
INFLATOR SAFETY WARNINGS
Always wear goggles and ear protection when using the machine.
Do not leave the appliance unsupervised when it is switched on.
Never direct any compressed air or blow any dust toward people
or animals.
Do not use the device in rooms with a potentially explosive
atmosphere.
Risk of Bursting. Do not overinfl ate. Follow all manufacturer's
instructions for the item. Do not set the tool to an output pressure
greater than marked maximum pressure of item to be infl ated.
Never block or plug the air outlet during operation.
Check air hose for wear or damage before each use. Check all
accessory connections are secure.
This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children
without supervision.
Have damage repared immediately by an authorised workshop.
Following 10 minutes of continuous operation, a short break of at
least 10 minutes must be taken to allow the device to cool down.
Remove the battery pack before starting any work on the
appliance.
To avoid injury and damage, never immerse the tool, removable
battery or charger in liquid or allow liquid to penetrate them.
Use only System M12 chargers for charging System M12 battery
packs. Do not use battery packs from other systems.
Never break open battery packs and chargers and store only in dry
rooms. Keep dry at all times.
425_402_M12BI_1-0.indd 11
To reduce the risk of fi re, personal injury, and product damage due
M12 BI
to a short circuit, never immerse your tool, battery pack or charger
in fl uid or al-low a fl uid to fl ow inside them. Corrosive or conductive
4674 79 01...
fl uids, such as seawater, certain industrial chemicals, and bleach or
... 000001-999999
bleach containing products, etc., Can cause a short circuit.
12 V
120 W
SPECIFIED CONDITIONS OF USE
120 PSI; 8,27 bar; 827 KPA
The infl ator is intended to infl ate items such as car tires, bike tires,
lawn equipment tires, sports equipment, air mattresses, beach toys
24,9 l/min
and other infl atables.
Do not use this tool to fi ll air tanks or shocks. Do not use this tool as
17,8 l/min
a breathing device. Do not use this tool to spray chemicals.
-18°C ... +50°C
MAINTENANCE
Remove the battery pack before starting any work on the
M12B...
appliance.
C12C; M12C4; M12-18 ...
The ventilation slots of the machine must be kept clear at all times.
66 cm
Service and repair work may only be carried out by authorised
1,42 kg
specialist workshops.
1,59 ... 1,83 kg
If the tool does not start or operate at full power with a fully char-
ged battery pack, clean the contacts on the battery pack.
If the tool still does not work properly, return the tool, charger and
battery pack, to a MILWAUKEE service facility for repairs.
Use only Milwaukee accessories and Milwaukee spare parts. Should
components need to be replaced which have not been described,
please contact one of our Milwaukee service agents (see our list of
guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please
state the Article No. as well as the machine type printed on the
label and order the drawing at your local service agents or directly
at: Techtronic Industries GmbH, Max-Eyth-Straße 10, 71364 Win-
nenden, Germany.
BATTERIES
Temperatures in excess of 50°C (122°F) reduce the performance of
the battery pack. Avoid extended exposure to heat or sunshine (risk
of overheating).
The contacts of chargers and battery packs must be kept clean.
For an optimum life-time, the battery packs have to be fully char-
ged, after use. Battery packs which have not been used for some
time should be recharged before use.
To obtain the longest possible battery life remove the battery pack
from the charger once it is fully charged.
For battery pack storage longer than 30 days:, Store the battery
pack where the temperature is below 27°C and away from
moisture, Store the battery packs in a 30% - 50% charged condi-
tion, Every six months of storage, charge the pack as normal.
Do not dispose of used battery packs in the household refuse or
by burning them. Milwaukee Distributors off er to retrieve old
batteries to protect our environment.
Do not store the battery pack together with metal objects (short
circuit risk).
Rechargeable batteries are to be removed from the appliance
before being charged;
If the appliance is to be stored unused for a long period, the
batteries should be removed.
Exhausted batteries are to be removed from the appliance and
safely disposed of.
The supply terminals are not to be short-circuited.
GB
English
11
26.01.18 09:14