IGM Professional Tools FK650 Mode D'emploi page 8

Operating instructions EN
Radius and 45° finishing of worktop corners
For radius finishing of corners use the E holes (fig. 20).
For beveling of corners to 45° use the F holes (fig. 21).
20
Insert the metal stops into the holes. Fix the jig FK to the edge of the worktop using the stops. Tighten the
jig to the kitchen worktop using the clamps and check that the clamps do not hinder the movement of the
router. Set the cutting depth on the router. Insert the router and begin to cut the joint on multiple-pass from
left to right. Copy according to the outer edge of the radius or groove.
• Always unplug the router when exchanging the router bit or setting the router.
• Use protection glasses when cutting.
• Use hearing protectors.
• Always use dust mask or respirator.
• Use dust exhausting plant.
• Don't wear loose clothing. Ensure that you have tucked your sleeves and that you don't wear any tie.
• Before switching the router on, remove all tools, nuts, keys and other free objects from the cutting area.
• Prevent unwanted switching of the router: ensure that the switch of the router is in position "off" before
plugging-in.
• Wait until the cutting bit is completely stopped before starting any setting of the router.
FK650 – FK651 SPARE PARTS LIST
Pos. # Description
2 Sliding stop 200x30x10 mm
3 Bolt-stop set 3 pcs D30/10x35 black
Set of connecting material for sliding stop
4 O rings set 6 pcs
8
21
SECURITY 1
Quantity Code
1 FK650-02
1 FK650-03
1 FK650-05
1 FS990001
www.igmtools.com
v .4